1. During operation, the Road Roller should start before it can start. The internal combustion engine should first go to medium speed and then modulate the high speed.

彩神ll用户登录 2. When the speed is changed and the direction of change, the engine should be stopped first, and the speed of the internal combustion engine should be reduced during the speed change.

3. It is forbidden for the Road Roller to vibrate on a solid ground.

彩神ll用户登录 4. When rolling soft and soft roadbed, it should be rolled 1 to 2 times without vibration, and then vibration rolling.

彩神ll用户登录 5. When rolling, vibration frequency should be consistent. To adjust your vibratory Road Roller, you must first adjust the vibration frequency before operating, and you must not adjust the vibration frequency without a shock.

彩神ll用户登录 6. The adjustment of the reversing clutch, the starting clutch and the brake should be performed after the main clutch is disengaged.

彩神ll用户登录 7. When using uphill and downhill, you cannot use fast gear. When a sharp turn is made, including the articulated vibratory Road Roller, the fast gear must not be used when rolling with small turns.

彩神ll用户登录 8. When the Road Roller is running at high speed, it must not join vibration.

9. When stopping, stop the vibration first, then place the reversing mechanism in the middle position, place the transmission in neutral, finally pull up the hand to brake the joystick, and the internal combustion engine will turn off after a few minutes of idling speed.

彩神ll用户登录 10. Other operating requirements shall comply with the provisions of hydrostatic Road Roller.